Best EEE Job Preparation Syllabus

It may require the EEE job preparation syllabus to the students who are the electrical job seekers in Bangladesh.

Stated here as a short topic, with reference books including chapter, for electrical circuits, electronics, machines, power systems, communication, control system, and other digital systems.

After getting your book List for EEE job preparation, you need to follow which topic you are actually needed. It is unpredictable to define a specific topic.

Analyzing the previous question of different examinations, we get these useful topics. For better preparation to compete with the job you may need more topics or more books. Decidedly you can now start to follow these topics. (For EEE Job Preparation Book List: Click Here ).

eee job preparation syllabus
EEE Job Preparation Syllabus

EEE Job Preparation Syllabus

For EEE job preparation syllabus shortly, your departmental part is sectionalized below:

  • Electrical Circuits
DC: Equivalent resistance, Delta-Wye Conversion; Node, Mesh, Thevenin, Norton, Superposition, Maximum power transfer, Source transformation Theorem; KCL, KVL, RC, RLC Circuits.
AC: Thevenin, Maximum power transform, Circuit theorem, First-order circuit; Average & RMS value, sinusoidal voltage & current, Lagging/Leading, Impedance, Mutual impedance, ac Power, Resonance; Phasor algebra, Phase sequence, 3-Phase circuit, Two-wattmeter method; Power factor, Power factor improvement.
Reference Books:
Funda. Electric Circuit- Alexander Sadiku- Chapter- 2, 3, 4, 5, 6, 7, 9 11, 12 & 13.
Int. Ckt. Analysis- Boylestad- Chapter- 5, 6, 8, 9, 11, 14, 16, 18, 20 & 23.
A.C. Circuits- Corcoran- Chap- 1, 2, 3 & 4
EEE job preparation syllabus for Circuits
  • Electronics
Diode-Semiconductor diode, ideal diode, Forward/Reverse bias, Zener breakdown, Zener diode; Clipper/Clamper circuit & its waveform; BJT-Configuration, Saturation, Circuit solution, Q point, Modes; FET-Basic configuration & circuit solution; MOSFET-pMOS, nMOS, Saturation, CMOS design, Triode; Op Amp-Comparator circuit solution, Inverting/Non-inverting, differential amplifiers, Summer/Differentiator, Oscillator, Op-Amp design, and Combined solutions.
Reference Books:
Elec. Devices Ckt Theory- Boylestad- 3, 4, 5, 6, 7, 8 & 8.
Microelectronic Circuits- Sedra Smith4
Op-Amp Lin Int. Ckt- Gayakward
EEE job preparation syllabus for Electronics
  • Electrical Machines
Operating principle, Electrical properties, Efficiency and Equivalent circuit of DC Generators & Motors, Transformer, 3-Phase transformer, Induction motor, Synchronous motor, and Alternator; Problem solution of these machines.
Reference Books:
A Textbook Electrical Tec. vol-2- B.L. Theraja- 26, 27, 28 29, 30, 32, 33, 34, 37 & 38.
Principles Elec. Machines- V.K. Mehta- 2, 4, 8, 9, 12 & 13.
Elec. Machinery Funda-Chapman- Chapter- 2, 4, 5, 6
Electric Machines- C. I. Hubert
Direct Alt Cur Machinery- Friedman
EEE job preparation syllabus for Machines
  • Power System
Transmission line performance, Capacity, Single line diagram, Zero sequence network, CT/PT, Circuit breaker, Switchgear protection, Sag, Load characteristics, Power factor improvement, Per unit system, Symmetrical/Asymmetrical fault, Reactance diagram.
Reference Books:
Principles of Power Sys- VK Mehta- Chapter-3, 6, 8, 9, 11, 13, 14, 15, 16, 17, 18, 19, 20, 21, 24
Elements of P.S. Analysis- Stevenson- Chapter- 6,10, 11 & 12.
Power System-Hadi Saddat
EEE job preparation syllabus for Power System
  • Communication
Signal operation, Fourier transform, Frequency response; Sampling theorem, SNR, Bandwidth, AM, FM, DSB, SSB, DSB-SC, PCM, DM, TDM, FDM, CDMA, Filtering, Digital modulation.
Reference Books:
Modern Digi. Ana. Com. System- B.P. Lathi- Chapter- 2, 3, 4, 5 & 6.
Com. Systems- Haykin
Data Com. Networking- Foroujan- Chap- 1, 2, 3, 4, 5, 6 & 7
EEE job preparation syllabus for Communication System
  • Control System
Transfer function, Block diagram, Rough table, First/Second-order circuit, Pole zero plot, Transient response, Single Flow Graph (SFG), Stability.
Reference Books:
Contro System Engg- Norman Nise- Chapter- 2, 3, 4, 5, 6 & 7
Modern Control Engg- Ogota
EEE job preparation syllabus for Control System
  • Others
PLC & Digital systems.
Reference Books:
Digital Log. comp Design- Morris Mano- Chap- 2, 3, 4, 5, 6
Continuous Disc. Sig. System- Solaiman Srinath
Short syllabus for others
  • Objectives
Reference Books:
Elec. Elen. and Telecom Engg – Theraja
Obj. Elec. Tech. – Mehta
EEE Objectives Books

Gentlemen, you are requested to import a comment if any useful or important topic is missing.

Leave a Reply